LA GARD 700 Series locks can be purchased from our online store, with discounts for security trade customers.

Introduction

700 Series locks are provided by Safelock Systems ready to operate with the default codes below:

IDProfile(ID) Default Code
00Master(00) 87654321
01Manager(01) 123456

Instructions to install locks and keypads are available to download from our website.

Do not apply power to the lock system until the keypad has been plugged into the lock’s ENT port.

Once the lock has been installed and the mechanical function has been tested using the Manager ID and code to open, several steps should be followed by installers to ensure correct operation of the lock system.

User operating Instructions

700 Series locks are provided with a printed copy of Standard User Instructions. A printable Quick reference guide is available to download from the relevant lock page on our main website, where the are also videos demonstrating procedures, and full instructions, including advanced Master and Manager procedures are available:

Step 1: Set date and time

To maintain the integrity of the audit, and to allow correct timelock operation, it is important to ensure that date and time is set on an annual basis and re-established after a power loss lasting for more than a few minutes. Locks are supplied without power connected, so the date and time must be set after the lock has been installed. If the date and time is not set, the lock reverts to 00:00 on the 2nd January 2000.

Date and time: Non-display keypads

  • Enter #65
  • Enter the Master ID (00) and code
  • Enter 10 digits to reflect the date and time in the format (YY) (MM) (DD) (24HR)
  • Press Enter. If accepted, the lock will signal 3 green flashes + short beeps ☼☼☼

Example date and time:

22nd July 2022, 2:30pm 2207221430

Example to set date and time:

Date and time: Display keypads

  • Either:
    • Enter the Master ID (00) and code or;
    • Press Arrow Down, then enter the Manager ID and code
  • Press Arrow Down to scroll to Time / Date, press Enter
  • Press Arrow Down to scroll to Set Time Date, press Enter
  • The display shows the current time and date, press Enter
  • Enter new values in the format shown onscreen, noting that the date starts with YY for Year

Step 2: Advise code change

As the Master code has the permission to completely control the lock system, including creating subordinate users who can open the lock, both the default Master and Manager codes should be changed immediately.

Opening codes should be changed and tested with the safe or vault door open where possible. Once changed, test that the new code works whilst the door is open.

Code change: Non-display keypads

  • Enter #52
  • Enter the current ID and code
  • Enter the current ID and new code twice
  • Press Enter. If accepted, the lock will signal 3 green flashes + 3 short beeps ☼☼☼

Example to change code:

Code change: Display keypads

  • Either:
    • Enter the Master ID (00) and code or;
    • Press Arrow Down, then enter another ID and code
  • Change combo may already be highlighted, if it is not, press Arrow Down to scroll to it, then press Enter
  • Enter the new code twice

Step 3: Checklist

  • Set date and time
  • Change Master code
  • Change Manager code
  • Demonstrate adding users
  • Set time delay if required
  • Cover features in Standard User Instructions if required